Aave raises USDC borrowing cap to $4 billion, tightening potential withdrawal buffer

  • LlamaRisk
  • Aave
  • USDC borrow limit
  • reserve utilization

LlamaRisk’s change took effect on November 20

At current supply, a full cap would mean 94.8% reserve utilization

LlamaRisk raised the USDC borrowing cap on Aave’s main Ethereum market from $2.7 billion to $4 billion on November 20, 2026. The change took effect at 11:15 UTC, minutes after LlamaRisk announced it in Aave’s governance forum.

The cap sets the maximum amount that users can borrow from the market. When LlamaRisk made the change, USDC loans had reached 98.5% of the old cap, while reserve utilization—the share of supplied USDC that had been borrowed—stood at 63.1%.

LlamaRisk’s governance post said borrowing to the new cap at current supply would raise reserve utilization to 94.8%, just above the market’s 94% optimal utilization ratio. That ratio is a benchmark for the market’s borrowing level, not a limit on withdrawals.

The higher utilization could leave lenders with less immediately available USDC to withdraw. Based on the supply and borrowing figures cited by Cryptopolitan, about 167 million USDC would remain available if borrowing reached the cap, down from about 1.06 billion at the time of the report. The article presents this as a possible outcome, not a report that withdrawals were already blocked.

LlamaRisk estimated that if deposits rose to the $5 billion supply cap, utilization at the new borrowing cap would be 80%. This is a conditional estimate; the article does not say that deposits had reached that level.

The change formed part of a wider set of Aave V3 parameter adjustments posted by LlamaRisk in the governance forum on November 20. The same package raised Aave V3 Core’s USDT borrowing cap from $2.7 billion to $2.8 billion; the governance post estimated that filling it at current supply would bring reserve utilization to 94.6%, close to the 94% optimal ratio.

Our priority is to report the news promptly and faithfully.
We use AI to write our articles. People oversee publication and review and correct articles when needed.
We leave it to readers to interpret the facts and draw their own conclusions.